Universal 3 Pin Relay for LED Turn Signal Flash Control
Our LED Relay is intended to replace your OEM relay when installing aftermarket LED Turn Signals on your motorcycle or when replacing a faulty existing Turn Signal Relay. This relay will prevent the hyperflashing caused by replacing stock Incandescent Bulbs with LED Lights.
Dimensions: See photos
Housing: High Impact PVC Plastic
Plug:Three pin, 12 Volt Systems
Install Notes: This can be used as a replacement for almost all 3 Pin 12 Volt Relays. This Relay has three pins labeled "B" for Battery, "L" for Load Terminal, and "P" for Panel (Dash terminal). It will fit all Motorcycles and Automobiles that utilize a 12v JSO (Japanese Standard Organization) Flasher Relay with no modification. Depending on your application it may be necessary to hard-wire the relay. If you have a Japanese Bike or Automobile with the same 3 pin layout then it will be a simple Plug-and-Play install. However if you have a Bike or Automobile manufactured outside of Japan that uses an ISO (International Standard Organization) style Relay then you can use this Relay by Hard-wiring it and simply switching the "B" and "P" Terminals. ISO and JSO Relays are the exact same, only the "B" and "P" pins are switched and opposite. On Motorcycles Relays are usually located under the side fairing, under the seat, or behind the instrument cluster. In automobiles you will usually find them behind the dash or close to the fuse box.
Universal - When hard-wiring the relay, the bike Make and Model options are too many to list.