One Pair - Kawasaki Turn Signal Wire Adapter Plugs
Front / Rear - 2 Pin - Square Connector
This Ninja Marker Wire Adapter plug connector allows you to exchange your OEM indicators for aftermarket blinkers with a simple plug n play install. Check your plugs to ensure connector style needed prior to purchase. This is a two pin connector; your system may have a three wire signal, this plug will delete the running light unless your system has the 3rd wire connected separately.Stats:
Pair: Two wire adapters (one for right side / one for left side)
Plug: OEM Direct Fit 2 Pin Plug
Wiring: Two Wire, 12 Volt Systems, Length is approximately 7.5 inches
May also fit other bikes. Please do your own research if replacing on a bike other than listed below.
Install Notes: We recommend disconnecting the battery before starting any electrical installation. The installation difficulty will vary depending on your application (fairing and wire location). You'll need to locate the existing Turn Signal Wires on your Motorcycle and remove your OEM flashers by unplugging them. Install your other lights and connect them to our wire adapter plugs bullet connectors. Then connect the adapter plug into the OEM plug coming from your bikes harness. We recommend reconnecting the battery and testing the lights before reinstalling the fairings.