The install steps will vary depending on your motorcycle, mounting to the license plate is usually very simple as the Blinkers mount directly to the License Plate Frame. You will have to do is run the existing turn signal power wires close to your license plate to supply these lights with power.
This is an LED Turn Signal, LED Signals can increase the Flash Rate of your turn signals.
Flash Controllers are not required but recommended to correct this hyper flashing.
They are available separately in our Store
Wiring: Two Wire, 12 Volt Systems
Bulb: 10 Watt Single Filament Bulb for Non LED version OR
7 High Intensity LED Diodes (Flash Controllers suggested to control Hyper-Flashing)
Install: Universal Turn Signal Light, installation will vary depending on your
application, installation may require modification.