Grips - CNC Shadow

60-810-SV
  • $14.99
  • Save $10
Shipping calculated at checkout.


Our Shadow Grips are made of a strong, durable rubber that increases grip, reduces vibration, stands up to constant abuse, and is treated to reduce UV damage. Installation of bar-ends may require cutting the grip ends with a sharp razor.

Grip Inner Housing: Rubber
Grip Outer Housing: Anodized CNC Billet Aluminum

Fits:
7/8 Inch Diameter Handlebars

Install Notes:
When you open the package you will notice that one grip has a larger inner diameter than the other. The larger inner diameter grip is for the Throttle side (right side), while the smaller inner diameter is for the Clutch side (left side). Remove your old grips from the handlebar, then clean all of the glue and dirt residue from the throttle plastic and the handlebar. You do not need to use glue to install our hand grips as they are desinged to install with a compression fit. However, glue can aid in the installation and result in a longer lasting end product. Alternatively, you can also use warm soapy water or glass cleaner to slide the grips on more easily. Do not use petroleum based lubricants as they will leave a slick residue, allowing the grip to slide off easily while riding. Do not use compressed air or a screwdriver to install, as this can result in damaging the grips. Some of our grips have closed ends. To use with bar-ends, simply cut a small hole in the end with a sharp

Replaces these OEM Part Numbers:
(Will also fit other part #'s)
N/A


We Also Recommend