LED Turn Signal Surface Mount - Universal - Skink

SKU: 15-506

Availability: In stock

Regular Price: $14.95

Special Price: $7.95

* Required Fields

Regular Price: $14.95

Special Price: $7.95


One Pair - Universal LED Turn Signals
- 1 White Light Emitting Diode

Are you tired of bumping into your old, over-sized side markers? Do you need to replace a broken OEM Turn Signal Light or just want to add to your existing system? We have just the Blinker for you. Try our Universal Compact Surface Mount Turn Signals. Our LED Signals are designed with a High Impact PVC Plastic Lens that can be mounted with applied 3M tape. These Signals are universal, so you can install them on the front or rear with little to no modification, depending on your application.

Dimensions: Multiple, please see photo(s)
Housing: High Impact PVC Plastic
Wiring: Two Wire, 12 Volt Systems

Fitment Information: This is a Universal LED Turn Signal Light; therefore, it has unlimited uses and mounting possibilities. This includes, but is not limited too: Sportbikes, Cruisers, Scooters, ATV, Quad, UTV, MX, Dirt Bike, Enduro, Dual Sport, Golf Carts, Trailers, and even Snowmobiles.

NOTE 1: This is an LED Turn Signal and can increase the Flash Rate of your turn signals. Flash Controllers (Resistors or LED Relays) are not required, but are recommended if you want to correct the hyper flashing. Resistors and Relays are available separately

Install Notes: Always test the lights before installation to ensure they work properly. Use a FULLY charged Battery or a running motorcycle to test lights. After testing, we recommend disconnecting the battery before starting signal installation. The installation difficulty will vary depending on your application; depending on where you decide to mount them, it may require modification to the fairing. Once you pick a mounting location, you'll need to locate the existing Turn Signal Wires on your Motorcycle and identify whether you have 2 or 3 Wire System. For a motorcycle with a 3 Wire System: your Running Light Wires are not used for this installation as our lights are not designed or marketed for that application. For a 2 Wire System: the two wires coming from your bike should be the Turn Signal Power (Positive Wire), and a Ground (Negative Wire). Attach our RED Turn Signal Wire to the Bikes Positive Signal Wire. Attach our BLACK Turn Signal Wire to the Bikes Negative Signal Wire. Test the light functions properly prior to putting everything back together. If it's good, repeat the process for the other side. Reassemble, Ride and Enjoy!


Click on above image to view full picture

  • LED Turn Signal Surface Mount - Universal - Skink