1x - LB Brake Light Strobe Module - Taillight Flasher
Get their attention - Before they get you! Our flash controller is programmed so that each time you hit the brakes your lights will flash 4x fast, flash 4x medium, and then stay illuminated as long as you're holding the brake. Release the brake and hit it again to reactivate the strobe sequence. Works great with LED systems, but can also be used on lower wattage incandescent bulbs. To install you will need to either splice your existing wires or use our Wire Adapters found in our store. You can also visit our Storefront to see our other Flash Controllers, Resistors, and LED Relays.
Dimensions: See Picture(s) for Approx Measurements.
Housing: High Impact PVC Plastic, Water Resistant
Wire Length: Approximately - 5 3/4 inches each wire
Wiring: 18 AWG, 2 Wires In / 2 Wires Out
Rated Input Voltage: 12-24 Volt DC Systems
Rated Input Current: 0.8A to 1.2A
Rated Power: 10-15 Watts
Working Temperature: -40°F to 122°F (-40°C to 50°C)
Storage Temperature: -58°F to 176°F (-50°C to 80°C)
NOTE: Depending on your light system and set-up, you may need to wire more than one Module into your system (Example: Split Taillights with higher wattage incandescent bulbs that collectively exceed the rated power for one module). Do your electrical research for your application before purchasing.
Fitment Information: This is a universal product; therefore, has multiple make and model fitments and applications. This includes, but is not limited too: Sportbikes, Cruisers, Scooters, ATV, Quad, UTV, MX, Dirt Bike, Enduro, Dual Sport, Golf Carts, Trailers, Automobiles, and even Snowmobiles.